Hawk Pro NTN note: All firmware features for the Hawk Pro are shared with the Hawk Pro NTN. The Hawk Pro NTN runs on an upgraded nRF9151 modem (vs nRF9160 on Hawk Pro), has a simplified UVLO, automatic Vbatt/Vext detection, and firmware-controlled charge rate (replacing the physical charge-rate switch). For full hardware differences, see the Hawk Pro vs Hawk Pro NTN article.
Adds the ability to update the BLE Cards' BLE Module FW OTA.
This update also requires BLE v1.8 in order to update the module.
1.12
Add parameter to optionally disable PCB debug interface
1.11
Fixed a rare issue in FW v1.8, v1.9 and v1.10 where if the schedule period for “Minutes Synced to Hours” was set to 60, the device was unable to upload.
1.10
External voltage is sampled when connected/removed
Fixed a bug where external voltage wouldn't get updated if the device didn't sleep
1.9
Support for 5 actions per task
Increased the maximum number of registers to 40 for the Modbus Action (Registers mapped to Analogs 21+ will not show on TG).
Fixed timeout race condition on boot that could render device bricked until hard reset
Fixed 10s LED flashing on commit being cut-off early in stay-connected mode if the device needed to reset
Fixed issue with synced tasks running twice when time is updated
1.8
Support for upload only tasks (i.e. no gps fix or card action).
On power on reset, LED flashes rapidly for 10s on successful commit (data upload) to the server.
Set vbat good status flag if charger is disabled. Fix for TG showing low battery indicator.
Support for running tasks synced to hours.
1.7
Added 4 addititional Digital Input monitors a total of 6.
Added 2 additional Analog Monitors for a total of 4.
Introduced the ability for Analog Monitors to monitor whether a value is inside or outside of a range.
